Editing

How to use Rungaroo

  1. Run it. Run starts the scan cycle. Step runs exactly one scan. Stop returns to editing.
  2. Operate it. While it runs, flip the inputs in the panel, or tap a contact that reads an input. Energised wires are green.
  3. Edit it. Pick a tool from the palette, then tap a cell. The next cell is then highlighted: tap another tool to place it there straight away, or choose Edit to put the highlight away. In a function block diagram, tap the canvas to place a block, drag from pin to pin to wire, and drag a block to move it.
  4. Look closer. Trend plots variables over time. The panel tabs hold the watch table, forcing, alarms and a recorder for input sequences.
  5. Start from an example. Project lists six examples, each with a recorded test run, and keeps all your projects on this device.
  6. Keep it. Project saves your work to a file. Add the app to your home screen to use it offline.

Rungaroo is a learning and simulation tool. It does not connect to a real PLC.

Version 2.0 · Source code and documentation on GitHub

Project

One scan reads the inputs, runs every rung and writes the outputs. Timers advance by this amount per scan.

Keep or move your work

Projects are saved in this browser as you edit, on this device only. A file is the safe copy, because browsers can clear their storage, and it is how a project gets to another device. If Save to file does nothing where you opened the app, use Copy as text.

Offline use

Checking…